Ceiling fan installation in Sydney

Finding an electrician in Sydney who turns up

The hardest part of getting electrical work done in Sydney is not the work. It is finding someone who shows up when they said they would, tells you the price before they start, and does not leave you chasing them for a certificate afterwards.

We work across Sydney and the suburbs around it, including Sydenham, Sydney, Sydney Olympic Park. The price is agreed before anything starts, coming out to look costs nothing, and the labour is guaranteed for as long as you own the place.

What makes Sydney different to work in

Sydney has the mix you find across a lot of Sydney: older homes still running the board they were built with, sitting next to places that have been renovated two or three times. Both throw up their own problems, and both are jobs we do every week.

Older wiring around Sydney was never designed for the load a modern kitchen puts on it. Add an induction cooktop or a second fridge and the weak point shows up quickly.

Fitting ceiling fans in Sydney homes

The part people underestimate is the mounting, not the wiring. A fan puts a constant vibrating load on the ceiling, so it has to be fixed to something structural. Screwing a fan into plasterboard alone is how they end up wobbling and eventually coming loose.

If you are replacing an existing light with a fan, there is often no separate switch for the fan speed, so that needs running or a remote fitted. Worth knowing before you buy the fan.

In older Sydney homes the ceiling rose may not be in the middle of the room, which matters more with a fan than with a light. We can usually move it, but it is easier to know that before we start.

What usually causes it around Sydney

A lot of it is previous work. Extensions, added outlets and half finished jobs by whoever was cheapest at the time. You end up with a system nobody has ever looked at as a whole.

Water gets in more often than people expect. A roof leak above a light fitting, condensation in an outdoor outlet, or a subfloor that stays damp will all eventually cause tripping.

What ceiling fan installation costs in Sydney

We do not publish a price for this, and you should be careful of anyone who does. Two houses in Sydney on the same street can need very different work depending on the age of the wiring and what has been added to it over the years.

What we can promise is the shape of it. We come out and look for nothing, we work out what the job actually needs, and we give you one fixed number for the whole thing. If we find something unexpected once we are into it, we stop and talk to you rather than adding it to the bill. The number you agreed is the number on the invoice.

How we work compared to an hourly rate

Plenty of electricians around Sydney charge by the hour. It sounds cheaper and often is not, because you are carrying all the risk. If the job takes longer than expected, that is your problem. If someone is slow, that is also your problem.

We price the job, not the time. That means we carry the risk of it taking longer, which is a good incentive for us to turn up prepared. It also means you can say yes or no with the full number in front of you.

What you can safely do yourself

Almost nothing, and that is not us protecting our own work. In New South Wales it is against the law for an unlicensed person to do fixed electrical wiring, and the insurance consequences of a fire traced back to unlicensed work are severe. Replacing a plug top on an appliance or changing a lamp is fine. Anything behind the wall or inside the board is not.

The most helpful thing you can do is pay attention to the pattern. Does it trip only when the dryer runs? Only when it rains? Only in one room? That detail often points straight at the fault and saves a lot of hunting.

Renting in Sydney, or managing a building?

If you rent, electrical repairs to the property itself are the owner's responsibility, and urgent electrical faults fall under urgent repairs in New South Wales. Talk to your agent first. If it is genuinely dangerous, say so clearly, because that changes how quickly it has to be dealt with.

If you manage a strata block around Sydney, we can work on common property and bill the body corporate directly, and we can keep the same electrician on your building so nobody is relearning the site every visit.