Most people in Concord do not go looking for an electrician until something has already stopped working. The light in the hallway starts flickering, the board trips every time the kettle goes on, or there is a smell near a power point that was not there yesterday. By that point you are not comparing five quotes, you want someone who answers the phone and can tell you what is actually wrong.
Concord is inside our normal run, as are Homebush, Five Dock, Burwood. We quote the whole job as one number before we start, and we do not charge to come and look at it.
Concord has the mix you find across a lot of Sydney: older homes still running the board they were built with, sitting next to places that have been renovated two or three times. Both throw up their own problems, and both are jobs we do every week.
Renovating in Concord is usually when the wiring gets looked at properly for the first time in decades. Better to know before the walls close up.
Most homes in Concord were wired for a fraction of what a modern household plugs in. Four outlets in a whole living room, none in the right place, and a kitchen running an air fryer, a microwave and a kettle off the same circuit. Adding outlets properly means checking the circuit can carry it, not just running another lead.
On lighting, the biggest single change is swapping halogen downlights for LED. Old halogens run hot, which is a genuine fire risk where insulation has been pushed up against them, and they cost a great deal more to run. Swapping them is usually quick.
If your lights dim when an appliance kicks in, that is worth mentioning. It often points at something upstream rather than the light itself.
Most of what we find comes down to load. The house is doing far more electrically than it was built to do, and the weakest joint in the chain is where it shows up first.
Rodents are a genuine cause and an unglamorous one. Possums and rats in the roof chew cable insulation, and the fault that follows can be intermittent and hard to trace.
The real answer is that it depends on the condition of what is already there. That is not a dodge, it is why we come and look before quoting rather than pricing blind over the phone.
What we can promise is the shape of it. We come out and look for nothing, we work out what the job actually needs, and we give you one fixed number for the whole thing. If we find something unexpected once we are into it, we stop and talk to you rather than adding it to the bill. The number you agreed is the number on the invoice.
Plenty of electricians around Concord charge by the hour. It sounds cheaper and often is not, because you are carrying all the risk. If the job takes longer than expected, that is your problem. If someone is slow, that is also your problem.
We price the job, not the time. That means we carry the risk of it taking longer, which is a good incentive for us to turn up prepared. It also means you can say yes or no with the full number in front of you.
Almost nothing, and that is not us protecting our own work. In New South Wales it is against the law for an unlicensed person to do fixed electrical wiring, and the insurance consequences of a fire traced back to unlicensed work are severe. Replacing a plug top on an appliance or changing a lamp is fine. Anything behind the wall or inside the board is not.
The most helpful thing you can do is pay attention to the pattern. Does it trip only when the dryer runs? Only when it rains? Only in one room? That detail often points straight at the fault and saves a lot of hunting.
If you rent, electrical repairs to the property itself are the owner's responsibility, and urgent electrical faults fall under urgent repairs in New South Wales. Talk to your agent first. If it is genuinely dangerous, say so clearly, because that changes how quickly it has to be dealt with.
If you manage a strata block around Concord, we can work on common property and bill the body corporate directly, and we can keep the same electrician on your building so nobody is relearning the site every visit.
