The hardest part of getting electrical work done in Mosman is not the work. It is finding someone who shows up when they said they would, tells you the price before they start, and does not leave you chasing them for a certificate afterwards.
We work across Mosman and the suburbs around it, including Cremorne, Neutral Bay, Cammeray. The price is agreed before anything starts, coming out to look costs nothing, and the labour is guaranteed for as long as you own the place.
Mosman has the mix you find across a lot of Sydney: older homes still running the board they were built with, sitting next to places that have been renovated two or three times. Both throw up their own problems, and both are jobs we do every week.
A lot of the calls we get from Mosman start the same way: the board trips, someone resets it, and a week later it trips again. That pattern usually means a fault worth finding properly.
Most homes in Mosman were wired for a fraction of what a modern household plugs in. Four outlets in a whole living room, none in the right place, and a kitchen running an air fryer, a microwave and a kettle off the same circuit. Adding outlets properly means checking the circuit can carry it, not just running another lead.
On lighting, the biggest single change is swapping halogen downlights for LED. Old halogens run hot, which is a genuine fire risk where insulation has been pushed up against them, and they cost a great deal more to run. Swapping them is usually quick.
If your lights dim when an appliance kicks in, that is worth mentioning. It often points at something upstream rather than the light itself.
Most of what we find comes down to load. The house is doing far more electrically than it was built to do, and the weakest joint in the chain is where it shows up first.
Water gets in more often than people expect. A roof leak above a light fitting, condensation in an outdoor outlet, or a subfloor that stays damp will all eventually cause tripping.
The real answer is that it depends on the condition of what is already there. That is not a dodge, it is why we come and look before quoting rather than pricing blind over the phone.
What we can promise is the shape of it. We come out and look for nothing, we work out what the job actually needs, and we give you one fixed number for the whole thing. If we find something unexpected once we are into it, we stop and talk to you rather than adding it to the bill. The number you agreed is the number on the invoice.
Plenty of electricians around Mosman charge by the hour. It sounds cheaper and often is not, because you are carrying all the risk. If the job takes longer than expected, that is your problem. If someone is slow, that is also your problem.
We price the job, not the time. That means we carry the risk of it taking longer, which is a good incentive for us to turn up prepared. It also means you can say yes or no with the full number in front of you.
Almost nothing, and that is not us protecting our own work. In New South Wales it is against the law for an unlicensed person to do fixed electrical wiring, and the insurance consequences of a fire traced back to unlicensed work are severe. Replacing a plug top on an appliance or changing a lamp is fine. Anything behind the wall or inside the board is not.
What you can usefully do is narrow it down before you ring. Note which circuit trips, whether it trips straight away or after something specific gets switched on, and whether it started after a storm or a new appliance. That saves time on site.
If you rent, electrical repairs to the property itself are the owner's responsibility, and urgent electrical faults fall under urgent repairs in New South Wales. Talk to your agent first. If it is genuinely dangerous, say so clearly, because that changes how quickly it has to be dealt with.
If you manage a strata block around Mosman, we can work on common property and bill the body corporate directly, and we can keep the same electrician on your building so nobody is relearning the site every visit.
