The hardest part of getting electrical work done in Tempe is not the work. It is finding someone who shows up when they said they would, tells you the price before they start, and does not leave you chasing them for a certificate afterwards.
We work across Tempe and the suburbs around it, including Sydenham, Marrickville, Arncliffe. The price is agreed before anything starts, coming out to look costs nothing, and the labour is guaranteed for as long as you own the place.
Tempe has the mix you find across a lot of Sydney: older homes still running the board they were built with, sitting next to places that have been renovated two or three times. Both throw up their own problems, and both are jobs we do every week.
Renovating in Tempe is usually when the wiring gets looked at properly for the first time in decades. Better to know before the walls close up.
Most homes in Tempe were wired for a fraction of what a modern household plugs in. Four outlets in a whole living room, none in the right place, and a kitchen running an air fryer, a microwave and a kettle off the same circuit. Adding outlets properly means checking the circuit can carry it, not just running another lead.
On lighting, the biggest single change is swapping halogen downlights for LED. Old halogens run hot, which is a genuine fire risk where insulation has been pushed up against them, and they cost a great deal more to run. Swapping them is usually quick.
If your lights dim when an appliance kicks in, that is worth mentioning. It often points at something upstream rather than the light itself.
Most of what we find comes down to load. The house is doing far more electrically than it was built to do, and the weakest joint in the chain is where it shows up first.
Storms take a toll, especially on anything overhead. A surge through the supply can quietly damage a board or an appliance and the symptoms show up weeks later.
We do not publish a price for this, and you should be careful of anyone who does. Two houses in Tempe on the same street can need very different work depending on the age of the wiring and what has been added to it over the years.
What we can promise is the shape of it. We come out and look for nothing, we work out what the job actually needs, and we give you one fixed number for the whole thing. If we find something unexpected once we are into it, we stop and talk to you rather than adding it to the bill. The number you agreed is the number on the invoice.
The usual model in this trade is a call out fee plus an hourly rate plus parts. You find out the total when it is finished. We think that is backwards, so we quote the job instead of the clock.
We price the job, not the time. That means we carry the risk of it taking longer, which is a good incentive for us to turn up prepared. It also means you can say yes or no with the full number in front of you.
Almost nothing, and that is not us protecting our own work. In New South Wales it is against the law for an unlicensed person to do fixed electrical wiring, and the insurance consequences of a fire traced back to unlicensed work are severe. Replacing a plug top on an appliance or changing a lamp is fine. Anything behind the wall or inside the board is not.
Before you call, switch off the appliance you suspect and see whether the problem goes away. If the board holds with that one thing unplugged, you have found it, and the visit gets much shorter.
If you rent, electrical repairs to the property itself are the owner's responsibility, and urgent electrical faults fall under urgent repairs in New South Wales. Talk to your agent first. If it is genuinely dangerous, say so clearly, because that changes how quickly it has to be dealt with.
If you manage a strata block around Tempe, we can work on common property and bill the body corporate directly, and we can keep the same electrician on your building so nobody is relearning the site every visit.
